| STROKER MOTORS - EXTRA FOR MACHINING | 65.00 |
| S&S SIDEWINDER MOTORS - EXTRA FOR MACHINING | 65.00 |
| Complete Evo motor job, Labor Only (includes boring and valve job) | 450.00 |
Complete Motor Job—74 and 80 inch, Labor Only
(includes boring and valve job) | 450.00 |
| Lower End Only—74 and 80 inch, Labor Only | 175.00 |
Complete Sportster Motor Job, Labor Only
(Includes boring and valve job) | 550.00 |
| Sportster Lower End Only, Labor Only (Includes transmission) | 350.00 |
| Complete 45 Motor Job, Labor Only (Includes boring and valve job) | 300.00 |
| 45 Lower End Only, Labor Only | 175.00 |
| 74 Transmission—4 speed, Labor Only | 100.00 |
| 5 speed transmission | 125.00 |
| Unleaded Conversion with Port and Flow | 445.00 |
Shaved 74 Flywheels 1/8 Right Side, 5/8 Left Wheel
(Must Be Balanced)—Per Set | 65.00 |
| Glass Bead Motor Cases—Per Half | 25.00 |
| Boring—Per Hole | 20.00 |
| Valve Job—Per Set of Heads | 95.00 |
| Glass Beading—Per Piece. Either Per Cylinder or Per Head | 10.00 |
| Head Porting—Per Seat (includes valve job & spring set up) | 245.00 |
| Flywheel Balancing Statically | 60.00 |
| Head Shaving—Per Set | 40.00 |
| Line Boring—Case to Case | 25.00 |
| Rebuild Rods, Comes with Pin & Rollers | 85.00 |
| Valve Spring Shimming for Hi Lift Cams | 45.00 |
| Flywheel Trueing | 45.00 |
| Mismatched Cases Fly Cut and Line Bored | 85.00 |
| Breather Gear Hole in Case Resleeved (welding extra if needed) | 175.00 |
| Broken Motor Mounts (welded and machined) | 65.00 |
| Sportster Shaved Wheels 3/16 Left and Right Side—Per Set | 65.00 |
1000cc Sportster Barrels to Fit 900 Lower End,
Send Case and Barrels Only | 245.00 |
| Pan or Shovel Heads Fly Cut if Steel Inserts are Pulling Out—Per Set | 40.00 |
| Bore Early Case for Late Cam Needle Bearing | 45.00 |
Weld and Re-machine Crack in Left Case from Main Bearing Hole
to Timing Plug Hole (Must have both cases) | 85.00 |
| Rebuilt and Machine Scrapers Each Side — Per Set | 125.00 |
| Sportster Shaved Flywheel — Per Set | 65.00 |
| Generator Sections Replaced With Sand Casted Section | 245.00 |
Resleeve and Bore Left or Right Main Bearing Hole to S.TD.
(Must have both cases and bolts) | 295.00 |
| Valve Guide Hole Welded Up and Bored for Sb. Guide | 75.00 |
| Weld Up and Relocate Counter Shaft Hole (only) | 195.00 |
| Shovel Exhaust Port Threads Repaired | 15.00 |
| EVO Head Fly Cut for More Compression | 40.00/set |
